Updating satilite receiver executive search dating service

posted by | Leave a comment

Once you’ve obtained all these values from this site, preset the elevation and dish skew and point the dish at a landmark indicated by the alignment line on the map. On the receiver, check the satellite signal strength and the network ID of the transponder; it should match the satellite you intend to receive.Move the dish slightly to the left/right and up/down in very small steps and very slowly and watch the signal strength bar on the receiver to do the fine-tuning.Click and drag the marker along the alignment line to find out if an obstacle in the distance (e.g.a tree) is high enough to cause interference with the signal or even block the signal completely.From your location, it is theoretically possible to obtain satellites from an arc range of 160°, that is 80° West and 80° East. But this doesn’t mean that all the satellites within this range broadcast their signals down to your location.Depending on the transponder on the satellite, the signal is beamed to various spots on earth creating the so-called footprints.

That means if you happen to be in the center of the footprint, you can have a smaller dish size than if you live to nearer the edge, or the other way around: the further you live from the footprint center, the bigger the dish has to be.

These are all specific to your location and the chosen satellite.

The azimuth tells you the direction in which to point the antenna.

You should also do the LOS for each satellite you want to receive bearing in mind that the signal comes from a different direction than the one where the dish points to.

You can use the obstacle marker (the little green balloon) to check for line of sight (LOS) to the satellite.

There are even features for doing a self-installation of a multi-lnb dish (such as the 5LNB Direct TV, Dish Network 1000 dishes or Wavefrontier Toroidal T90 dishes), or a motorized system (with or without USALS).

Leave a Reply

lovedatingmarriage com